日本SMC兩通電磁閥閥形式

注1）的“L"選項是無油處理。
注2）的流體的動態粘度必須不過50毫米2 /秒。
電樞的特殊構造中采用的內置全波整流型通過在提供間隙給出OFF反應的改進
表面吸收，當它被接通。

選擇直流規范?；蚪涣饕?guī)范。內置全波整流型時的動態粘度比水高，或當斷開響應被先。
注3）線圈絕緣型H級：AC規范。只要
注4）螺母（非潮濕部件）都是鍍鎳的黃銅（C37）的材料。
注5）是附連到DC規范沒有遮光線圈?；駻C規格內置全波整流式。
*請與本公司時，流體除以上使用。

日本SMC兩通電磁閥閥形式

Note 1) “L" option is the oil-free treatment.
Note 2) The dynamic viscosity of the fluid must not exceed 50 mm2/s.
The special construction of the armature adopted in the built-in full-wave rectifier type gives an improvement in OFF response by providing clearance on the
absorbed surface when it is switched ON.
Select the DC spec. or AC spec. built-in full-wave rectifier type when the dynamic viscosity is higher than water or when the OFF response is prioritized.
Note 3) Coil insulation type Class H: AC spec. only
Note 4) The nuts (non-wetted parts) are nickel-plated on the Brass (C37) material.
Note 5) There is no shading coil attached to the DC spec. or AC spec built-in full-wave rectifier type.
? Please contact SMC when fluids other than above are used.